Warning zone lights


Simply avoid accidents

Prevent accidents during operation with industrial trucks and protect your employees from injury.

Mark the areas with an increased risk. Even if they are not stationary, but also move with the vehicle! Whether it is a tug truck, a forklift truck or gantry crane.

 

Easy installation, rapid effect!

Our Warning Zone Lights limit the risks of injury, not the use of your vehicles. They are mounted quickly and operate easily with their wide- range input of 12-110 V on almost any vehicle. Your employees do not need any briefing, because the function is self-explanatory.

Connect, align, finished! This is how passive safety must work.

 

 

Periphery Lights

Always stay on the safe side! With our modern marker lights, you effectively mark the border of an area of increased danger.

A clearly visible red, blue or yellow line on the ground informs passers-by that increased attention is required from there on. Boundary lines can be straight or curved.


Line

A Periphery light draws a visible colored line on the ground which uniquely marks the boundary of a danger zone.

These lights are ideal for the use on forklifts and lifting platforms.


Arc

The arc is a special form of marker light in which the warning line does not run straight but covers a radius of approx. 180 degrees in a comprehensive arc.

 

 

Model 793


Specifications

  • Operating voltage 12-36 or 48-90 V
  • Power consumption (W): 19.2–41.8 (red), 12–29.7 (blue), 12–29.7 (amber)
  • Operating temperature -40 bis 65°C
  • Sealed to IP67
  • Housing made of robust aluminium with polycarbonate lens

Possible applications

The Model 793 marker light is particularly suitable for smaller industrial vehicles such as pedestrian trucks, forklift trucks and tractors. It can be mounted on the overhead guard or on the lift mast. However, the sharp demarcation of the light image also allows stationary use, for example to mark walkways in halls with mixed traffic.

At the recommended mounting height of 2 m, the warning line has an effective length of 4.5 m.


Variants

Model 793 is available in three different coloured light patterns (blue line, yellow line and red line).

Model 777 II


Specifications

  • Operating voltage 12-72 V
  • Power consumption (W): 12.24-13.08
  • Operating temperature -40 bis 65°C
  • Sealed to IP67/IP69K
  • Housing made of robust aluminium with polycarbonate diffusing lens

Possible applications

Model 777 II is a unique marker light. Unlike model 793, which projects a straight line onto the ground, the line of model 777 forms a highly visible semi-circle next to or in front of a danger area.

Safe all around!
For a 360-degree safety solution, simply mount two warning zone lights, one at the front and one at the rear. Of course, an additional combination with further warning zone lights is also possible.


Variants

Model 777 II is available in three different coloured light patterns (red line, blue line and green line).

Model 529


Specifications

  • Operating voltage 12-24 V
  • Power consumption (W): 44,4-55,2 (rot), 46,8-57,6 (grün), 36,9-26,6 (blau)
  • Operating temperature -40 bis 65°C
  • Sealed to IP67/IP69K
  • Housing made of robust aluminium with polycarbonate diffusing lens

Possible applications

Model 529 is the equivalent of model 793, but significantly brighter. The application is clearly designed for larger vehicles.


Variants

Model 529 is available in three different coloured light patterns (red line, blue line and green line).

 

Area lights

Don't just mark the border, mark the entire danger zone! With the models 6150 BLU/RED and 527 RED you can do this with ease.


Area

With an area light, you immerse the entire zone of increased danger in clearly visible light. This way, the entire danger zone can be effectively marked.

 

Model 6150 BLU/RED


Specifications

  • Operating voltage 12-110 V
  • Power consumption (W): 13.8–15.4 (red), 13.8–18.7 (blue)
  • Sealed to IP67
  • Aluminium housing with a polycarbonate diffusing lens

Possible applications

The small area light model 6150 is also designed for use on small industrial vehicles. Here, however, due to the marking of a zone, an application on temporarily stationary vehicles, such as scissor lift work tables, lends itself.

With an installation height of 2 m, the warning zone has a size of approx. 2.5x0.6 m.


Variants

Model 6150 is available with blue or red light.

Model 527 RED


Specifications

  • Operating voltage 12-24 V
  • Power consumption only 20 W (@12 V)
  • Operating temperature -40 to 65°C
  • Sealed to IP69K
  • Housing made of resistant Xenoy with glass diffusing lens

Possible applications

Model 527 is intended for larger applications. Just like model 6150, this warning zone luminaire fills a sharply defined area with clearly visible red light. However, a significantly greater brightness is achieved here due to twice the number of LEDs, allowing a mounting height of 5 metres and a warning zone that is almost twice as large.


Montageorte

Typical installation locations for Model 527 are, for example, the rear of large industrial vehicles such as excavators or large dump trucks, which are difficult for the driver to see. But Model 527 can also be used to set up a zone for increased attention on bridge cranes or as a stationary solution, for example at gateways with dangerous operational traffic.

With a mounting height of 4 m, the warning zone has a size of approx. 4.7x1.2 m.

 

Spot lights

Sometimes it is enough to simply point out an approaching hazard without marking the boundary or the entire hazard area.

Be it a reversing forklift truck driving out of a poorly visible racking aisle or a suspended load on an overhead crane. Our spot lights help you announce the danger

Don't just mark the boundary, mark the entire danger zone! With the 6150 BLU/RED and 527 RED models, this can be done with ease.


Spot light

A spotlight projects a bright dot on the ground to indicate an approaching danger.

This principle is particularly suitable for narrow and unclear corridors and passageways.

 

Model 523 BLU/RED


Specifications

  • Operating voltage 24 V
  • Voltage converter for 230 V available
  • Aluminium housing with a glass lens

Possible applications

Model 523 is the spotlight for the larger scale. This warning light was specially developed for use on overhead cranes.

With a mounting height of 10 m, the spot has a size of approx. 1 m.


Variants

Model 523 is also available with blue or red dot. Of course, voltage transformers are available for use in various on-board networks.

Model 4415 BLU/RED


Specifications

  • Operating voltage 12-110 V
  • Power consumption (W): 22.92–19.8 (red), 24–27.5 (blue)
  • Sealed to IP67
  • Aluminium housing with a polycarbonate diffusing lens

Possible applications

Suitable for larger forklift trucks, tractors and other vehicles.

With a mounting height of 2.5 m and a distance of the point to the vehicle of 5 m, the warning point has a diameter of approx. 45 cm.


Variants

Model 4415 is available with blue or red dot.

Model 770 BLU/RED


Specifications

  • Operating voltage 12-110 V
  • Power consumption (W): 7.2–6.7 (red), 7.2–6.7 (blue)
  • Sealed to IP67
  • Housing and diffusing lens made of heat-conductive polycarbonate

Possible applications

The original! Model 770 was the first LED spotlight - hardly any warning device has established itself as a standard as quickly as the blue dot behind a forklift truck. It is suitable for all pedestrians, as well as small to medium-sized forklift trucks and other vehicles.

With a mounting height of 2 m and a distance of the dot to the vehicle of 5 m, the dot has a diameter of approx. 15 cm.


Variants

Model 770 is available with blue or red dot.

 

Projector

This new type of light is the sensible further development of the established spotlight. A clear statement and high visibility make it the tool of choice in cramped and difficult-to-see warehouses.


Warning sign projector

Instead of projecting a coloured dot as with the spotlight, the projector throws a flashing warning sign onto the ground. The warning effect is once again significantly increased compared to the spotlight.

A projector is also ideal for use on forklift trucks.

 

Model 560 "Projektor"


Specifications

  • Operating voltage 12-72 V
  • Power consumption (W): 43,3
  • Sealed to IP67
  • Housing made of robust Aluminum
  • Tough Polycarbonate lens

Possible applications

Just like spotlights, the projectors' main area of application will be a forklift truck. It is suitable for all pedestrians, as well as small to medium forklifts and other vehicles.


Variants

Model 560 is supplied with two symbols. Either with a blue forklift in a red triangle or with a red exclamation mark in a red triangle.

Other symbols are possible, please contact us.

Convince your customers with our Demo Case!

Send your field crew to your customers with our warning zone lights and the success becomes the norm.


Cemo Case

We have compiled a selection of different Warning Zone Lights for you. In a practical case, all lights with magnetic base, an integrated battery and a charger, you can demonstrate the function of the lights. Nothing is more convincing!


Content

The case contains one copy each:

  • Model 793
  • Model 6150
  • Model 4415
  • Model 770
  • Model 407
  • Battery
  • Charger
  • 2 m wire set

Customizeable

If necessary, we can also compile the case individually. Just contact us.